Just wondering if anyone else has ever had this issue. I'm trying to figure out if its an issue with the S7 or my PSUs.
The S7 will run for about 10-20 minutes before losing a board. It doesn't lose it completely. It shows that all ASICs are 0s, but the temperature drops down to about 20-25 C while the other boards are right around 60 C and hashing well. I thought at first I was drawing too much amperage on one circuit so I ran an extension cord to another circuit, but the same board just turned off by itself. I'm not sure if I have a bad PSU or if something is wrong with the miner. Any suggestions?
I've already done a few hard resets.
Submitted September 02, 2017 at 01:02AM by nplamers http://bit.ly/2gwAlkz
No comments :
Post a Comment